Bandit Alley

GENERAL MOTORCYCLE FORUMS => GENERAL MECHANICAL & TECHNICAL => Topic started by: salty on February 18, 2008, 04:21:02 PM

Title: Brake calliper Bolts?
Post by: salty on February 18, 2008, 04:21:02 PM

Does anyone know if the caliper bolts are the same for the four pot Nissin and the six pot Tokico's?
Thanks
Salty

Title: Re: Brake calliper Bolts?
Post by: Bob Holland on February 18, 2008, 04:31:40 PM

Quote from: salty on February 18, 2008, 04:21:02 PM

Does anyone know if the caliper bolts are the same for the four pot Nissin and the six pot Tokico's?
Thanks
Salty

I have the six pot Tokico's on my 98 B12. :motorsmile:

Title: Re: Brake calliper Bolts?
Post by: salty on February 18, 2008, 07:02:06 PM

did you use the bolts of your nissins?

Title: Re: Brake calliper Bolts?
Post by: Bob Holland on February 18, 2008, 08:15:56 PM

They were on the bike when I bought it. The bolts look stock, 30 mm long without the head, 10 mm O. D.,
14 mm head.

Title: Re: Brake calliper Bolts?
Post by: salty on February 19, 2008, 04:20:00 AM

I think i'm i need to pull a bolt and check it out, they may have a different pitch thread, i know the banjo bolts are a different thread,both 10mm but the pitch is not the same.
I was just being lazy hoping somebody new for sure.
Thanks for your help anyway.
Cheers
Salty

Title: Re: Brake calliper Bolts?
Post by: Red01 on February 19, 2008, 01:55:33 PM

Wish I would've thought about this Sunday night when my sone was over with his 1G, we could've done a side-by-side.  I'm pretty sure all you need it the calipers & the respective banjo bolts to swap between the two different rotor squeezers tho.