98 bandit, 35 k miles. 600s has been not runing since 99 ( rode it arround the block for 3 miles)
Is almost all back toghether, but as i m puting the last bolts on it, i noticed the gas tank leaked from the back botom part.
taking a closer look at it, it has pin holes all over. Tank is toasted.
So i m looking for a new(used) tank, do you know what other than 98 would fit my 600 ? would a 1200 fit ?
Also another isue, it starts with the choke and as it warms up, i need no choke BUT when i give it gas, it sometimes stays in the 2k range and then goes down back to 1k rpms.
So i moved the idle screw adjustment and it idles very ruff at 1k or 900 rpms if i open the idle screw more, the bike starts hanging in the 2k range and then going down to 1 k after 30 seconds or puting in first gear and leting the clutch a bit.
Otherwise runs great, accelerates really nice too.
The pilots are still factory sealed. I took the carbs out and cleaned them all the jets and passages inside the carb.
Adjusted the floats and everything looks in good working order.
jets are factory size.
any sugestions ?
thanks a lot
:)