FE Swap - using a GSXR Ignition switch on a B12

[UtterChaos]

Hi Guys,

Ok .. Front End Swap 98% Done  !!

Only one question - Can I use the GSXR ignition switch?

It's only got 4 wires (On-position loops two pairs)
But the B12's ignition switch has 3 Pairs (On loops all three but with a resistance on 3rd pair).
Two two pairs both have are the same - same colour even .. this works ok .. but the missing pair seem to go to the CDI.. and it won't spark without them 

It looks (From my wiring diagram) to be just a sidestand/clutch cutout ... but i'm not sure .. can I permanantly loop them?

Or maybe put in a relay from the power feed (after the switch obviously!)?

Any Ideas would realy help ... thnx

------------------------------------------------------------------------
Ok .. so apparently it's a security feature ... gonna need a diode in line .. anyone got ANY experience of this?
------------------------------------------------------------------------
Ok .. Sod-it ... Have removed GSRX switch (loads of drilling!) and will use Bandit one..... We'll see how it goes....
------------------------------------------------------------------------
All ok now .. er .. thanks for all your help everyone!!! ...     -  Did anyone actuially read this? .. Ahh well - next time it happens to someone else, at lease they'll have a solution.

Bye....

[Red01]

You logged 50 views as of the time I re-read this.  You probably didn't get a response becuase you asked if anyone had any experience or knowledge with this and no one that read it did... I know that's why I didn't say anything. 

Someone's gotta be a pioneer on every mod... looks like on this one, it was you.