Author Topic: RGV 250 Fork in B4 (Read 3294 times)

Dole · « **on:** November 05, 2005, 01:19:57 PM »

Hi again, does anybody know if the Fork from the RGV 250 fits without problems in the Bandit 400.
Can i have some probs. ?
Will the calippers from the Bandit fit ?

gsxr400 racer · « **Reply #1 on:** November 05, 2005, 03:36:54 PM »

if they ar USD no they wont fit what you want is fork from a gsxr 400 model gk73 these go right in and are the same calipers and all pritty much

Dole · « **Reply #2 on:** November 05, 2005, 07:25:44 PM »

is the gk73 an usd for ?
does a usd fork fit in a bandit ?

gsxr400 racer · « **Reply #3 on:** November 05, 2005, 08:29:29 PM »

gsxr 400 gk73 is not USD (up side down) and they go right in 88-89
An USD will fit if ya buy everything forks ,wheel, tripple trees, clip ons, axle !

stripes1976 · « **Reply #4 on:** November 05, 2005, 10:30:53 PM »

but if you want to fit USD's you will need a complete front end! Yokes,forks,wheel,spindle,mudguard etc etc

Red01 · « **Reply #5 on:** November 06, 2005, 12:46:40 AM »

Check out the Fork Swap thread in the B250/400 FAQ.

Dole · « **Reply #6 on:** November 06, 2005, 03:04:23 PM »

its a complete front-fork....
i thougt the wheel fits.

gsxr400 racer · « **Reply #7 on:** November 07, 2005, 09:12:05 AM »

then you are good to go , might have to change the races in the steering head if ya dont have them for tapered bearings like on that front end , wheel might fit but youll need some spacers, as long as all lines up your good!

gsxr400 racer · « **Reply #8 on:** December 04, 2005, 09:01:18 PM »

there is a year rgv that had conventional forks those will bolt right in!