Bandit Alley

MODEL SPECIFIC => SUZUKI BANDIT 250 & 400 => Topic started by: ovlovder on September 06, 2010, 07:16:08 PM

Title: doh, help with needle washer config
Post by: ovlovder on September 06, 2010, 07:16:08 PM

So, I seem to have forgotten which way these spacers/washers go on my factory pro needles.  The clips are on the middle notch.  I have the small plastic washers, the ufo spring seat washers, and some relatively thick metal washers.

I have been feeling like the ufo needs to be above the e-clip, and maybe the plastic one below.  Can anyone confirm?

Title: Re: doh, help with needle washer config
Post by: tomacGTi on September 06, 2010, 09:59:27 PM

From bottom to top:

-Needle
-Plastic doughnut
-e-clip
-metal washer
-spring seat
-needle spring

This is how DJ needles are anyway, I'm sure the FPs are very much the same.