Bandit Alley

MODEL SPECIFIC => SUZUKI BANDIT 250 & 400 => Topic started by: onenicebandit on June 17, 2006, 01:04:31 PM

Title: Float problems maybe?
Post by: onenicebandit on June 17, 2006, 01:04:31 PM

Well, I've been thinking, I don't  really know how to correctly set the float height on my  B400, I have the service manual, but it's a little sketchy on how to set them.  After 15 years, do you think they would be soaked and are just dumping gas into my cylinders.  I've got a new Ignitor coming for it, because it only costed me 20 bucks.  I seen a set of B4 carbs on ebay right now, BIN for 119 bucks.  I don't think I'm going to get them, but...just thought I'd throw them out to everyone.  Let me know guys if anyone had float probs.  

Chad

Title: Float problems maybe?
Post by: Red01 on June 17, 2006, 01:15:03 PM

If the floats are soaked (sunk), you'll be able to tell by removing them and listening for the sloshing sound of fuel inside the float chambers. This isn't unheard of, but is one of the rarer problems you'll find in a carb. More likely, if you've got flooding problems, the float needle & seat are leaking fuel past and not shutting the flow off like they should.

Title: Float problems maybe?
Post by: interfuse on June 17, 2006, 03:23:27 PM

Disconnect the tank with the petcock in the "on" position, if gas flows out freely you've got a bad fuel tap. Combine that with old orings, or dirty float valves and you'll end up with a crankcase full of fuel.

Title: Float problems maybe?
Post by: onenicebandit on June 19, 2006, 08:51:32 AM

Checked the fuel cock already, that is good to go.  This bike is driving me crazy!!! It's only got 2500 miles on it, I'm flippin out.  Someone wanna come over and work on it with me?  I'll pay ya.  :beers:   I want this bike to run so bad, I can taste it.  Dang thing anyways.

Title: Float problems maybe?
Post by: PitterB4 on June 19, 2006, 10:37:23 AM

Even with a good petcock, bad o-rings are going to let some extra fuel dump into the cylinders.  There are about a bazillion threads here about the pesky little bastards.  Your floats should seat firmly in the carb bodies.  If they're loose, you've got problems.  

Of course if your floats are way too high, that could cause the same thing.  To check the heights, you can use good calipers but a float height tool is WAY easier.

Title: Float problems maybe?
Post by: interfuse on June 19, 2006, 10:53:25 AM

Here's how you set the float hieght:

http://www.factorypro.com/tech/float_height_adj_procedure.html

I don't have a float hieght tool, I just use vernier calipers (modified to so the top arm is longer with a small straight edge and some tape...)