Bandit Alley

MODEL SPECIFIC => SUZUKI BANDIT 600 thru 1200 - AIR/OIL COOLED TECHNICAL => Topic started by: karl on December 24, 2006, 03:30:28 AM

Title: changing my front sprocket.
Post by: karl on December 24, 2006, 03:30:28 AM

right, i've decided to change my front sprocket for a tooth smaller. 14t. also my chain and rear spocket are still fine and  dandy, will it be ok to just change the front on its owt or will i need to do the chain and rear at the same time?

also. where can a get a sprocket for my front from? every where i've looked just sells standard kits (england)

thanks

Title: changing my front sprocket.
Post by: Ranger on December 28, 2006, 01:44:24 AM

:beers:

Title: changing my front sprocket.
Post by: karl on December 28, 2006, 02:44:26 AM

http://intobikes.co.uk/products?vhlMake=0004&vhlModel=002177&detail=product&id=001307&btnid=i2b_imgbut_0&sg=OR&mn%5B%5D=0025&x=29&y=9

found this plce.

Title: changing my front sprocket.
Post by: Ranger on December 28, 2006, 11:12:32 PM

:beers:

Title: Re: Front sprocket
Post by: karl on December 29, 2006, 05:47:13 AM

Quote from: "Ranger"

9.59 GBP   19 USD

Seems like pretty decent price.

Word of advice (actually two)
1. Putting a new sprocket on a worn chain will only wear out the new sprocket faster.
2. Before unbolting everything, leave the chain on the bike across both sprockets, place a board (2X4) between the spokes and the swingarm and using a socket, break the nut loose.  Do NOT put it in gear and hope that will stop the sprocket from turning or you might be looking at bent shiftforks and a transmission rebuild.

You "should" see a washer behind the nut with one or two flat spots, folded over the nut.  As I recall, that nut is somewhere around 32 mm

thanks.

 if it does wear faster, it doesn't cost much in the first place. but least then, after doing that mod i'll know if thats what i want to do when i do the complete change.