Bandit Alley

MODEL SPECIFIC => SUZUKI BANDIT 600 thru 1200 - AIR/OIL COOLED TECHNICAL => Topic started by: redbandit12 on March 15, 2008, 09:06:02 AM

Title: jetting
Post by: redbandit12 on March 15, 2008, 09:06:02 AM

1st gen 1200 with dale's stage 2 kit  holeshot full pipe. bike runs great wide open but if i get into traffic and need to ride below 3000 rpm's it will load up and foul a plug or 2. i think im 3 turns out on the mixture screws. what im asking is do the  needles need dropped or pilots need to be smaller? think im on the highest clip on the needles. jet kit was in before the pipe was put on this year

Title: Re: jetting
Post by: JamieK on March 15, 2008, 10:32:48 AM

Is the timing advancer in? I installed the stage1 without the timing advancer and it had symptoms much like yours...

Title: Re: jetting
Post by: redbandit12 on March 15, 2008, 10:47:41 AM

yes have that too just forgot about it

Title: Re: jetting
Post by: snofrog on March 23, 2008, 10:02:07 PM

how does the air filter look ?

Title: Re: jetting
Post by: redbandit12 on March 25, 2008, 05:21:04 PM

like it's brand new seeing how it only had 800 miles on when i  went to pod filters had to big of jets in it  i droped done to 32.5 and it runs much better