Author Topic: Condensation in Spark plug caps and plug housing. (Read 3081 times)

Mustang-Mel · « **on:** May 30, 2005, 05:22:24 AM »

Everytime after there's a down pour, I notice the engine becomes rough. On checking, I noticed water condensation in the spark plug caps and the area around the spark plug. I also noticed that the rubber seals that are supposed to keep the plug area free from water has breather holes in them.

To solve this maddening problem, I applied some clear silcon very sparsely over the "holes" as well as around the rubber seals of the HT cables. I left one "hole" clear, for obvious reasons.

Saves spending about S$100 for a set of 4 plug caps and their rubbers. Now, rain doesn't worry me anymore.

terrebandit · « **Reply #1 on:** May 30, 2005, 09:21:18 AM »

I'm not sure this is your problem. I think those holes are to promote air flow around the plug, to reduce heat, and keep the plug area dry. What you did will increase condensation/moisture, IMO. If any water accumulates in there, it is supposed to drain out the weep hole in the head. You should check to see if those holes are clear/not blocked.

Red01 · « **Reply #2 on:** May 30, 2005, 02:42:30 PM »

Additionally, you may want to add a dab of dielectric grease to the spark/lead connection.

Mustang-Mel · « **Reply #3 on:** May 30, 2005, 10:04:03 PM »

Thanks Terre, Paul.

Weep holes, now that's something new to me so I gotta check it out. I bought this bike 2nd hand and thus don't have any owners manual. So I learn as I go along with my basic vehicle maintenance knowledge that I acquired some 30 years ago.