Author Topic: Holy F@ck batman! Vinegar rocks!  (Read 9185 times)

Offline rider123

  • Board Homesteader!
  • ***
  • Posts: 991
Holy F@ck batman! Vinegar rocks!
« on: April 22, 2013, 05:54:29 PM »
The title says it all.

My girlfriend bought a 1985 Nighthawk 450 as her first bike with only 8000 Kms on the clock. However the loser who owned it bought it new then drove it for 2 years then let it park for 25 years with half a tank of gas  :duh: Fortunately before he stored it he drained the floats so the bike runs fine from an auxiliary tank. But of course the fuel tank was rusted to phuck. I mean this is literally the worst tank I've seen in 25 years of riding, not only was it rusty but there was 25 years worth of dead gas varnish as well. So I went and bought some very pricey Evapo-rust stuff that worked ok, but I couldn't afford to fill it up to the brim as it would have cost us $140 bucks just to do so. So after a little research I heard that you can put vinegar in there and it will clean it up. So I figured what the hell at $2 for 4L it would only cost $6 to fill the tank. So I filled it up to the brim with the vinegar and left it for 2 days. Holy F@ck batman! it came out like new inside! I'm doing another treatment now for a couple of days just to be sure all the rust is out of there. I've bought some baking soda to throw in there once the vinegar is drained to neutralize the acid and stop flash rusting. Give it a try it's one hell of a cheap fix. Just be careful not to leave the vinegar on the paint as it will eventually eat it.


What you need:

A shitload of vinegar(enough to fill right to the brim)
baking soda(to neutralize the acid)
patience(it takes a day or two)
WD-40(if you're not going to mount the tank right away as it will protect the metal)



2005 Bandit 1200, Modified Holeshot Stage 1 with 17.5 pilots 2.75 turns out, and 110 mains 5 shims. Muzzy Slip on w/mid-pipe, stock filter. 1.5" hole in the airbox lid.

Offline TJS

  • Board Homesteader!
  • ***
  • Posts: 409
Re: Holy F@ck batman! Vinegar rocks!
« Reply #1 on: April 22, 2013, 11:53:57 PM »
So, drain and add baking soda and water? Swish and drain?..or let sit for a day? Please post some pictures!
More Bandit 400 stuff on my youtube:
https://youtube.com/c/StanleysGarage369

Offline rider123

  • Board Homesteader!
  • ***
  • Posts: 991
Re: Holy F@ck batman! Vinegar rocks!
« Reply #2 on: April 23, 2013, 09:55:25 PM »
Yeah you got it.

You fill to the brim with vinegar let it sit for a few days. I attached a 12" piece of non-painted chain to a coat hanger and swished it around once and a while to help break up any scaling. After a few days empty out the tank and flush like crazy with water. At this point if there still is a little rust you can pop some more vinegar in there for another day or so.(what the hell it was $6) or if you think you're done then dump in some baking soda to kill the acid and fill it up a bit with water. Swish it around really well, or even better I filled it to the brim with the baking soda/water mix and let sit for a couple of minutes. Then flush out with water. The last step so you don't get flash rust is spray a can of WD-40 in there and swish it around really well. When you want to mount it on your bike flush out the WD-40 with a bit of gasoline and you're ready to rock.

I used a riding mower fuel filter that was designed for gravity feed(like our bikes) on the fuel line just in case there are a few piddly bits. I'm sure if you had a power washer you wouldn't even need to bother.
« Last Edit: April 23, 2013, 09:59:13 PM by rider123 »
2005 Bandit 1200, Modified Holeshot Stage 1 with 17.5 pilots 2.75 turns out, and 110 mains 5 shims. Muzzy Slip on w/mid-pipe, stock filter. 1.5" hole in the airbox lid.