Author Topic: Oil drain plug size (Read 7878 times)

Nick2k · « **on:** September 29, 2006, 10:41:27 PM »

What mm size is the oil drain plug?

I tried all the wrenches in my took kit, either too big or too small!

I don't have any metric wrenches over 19mm (besides my 24mm from my chain adjust), what size do I need?

andrewsw · « **Reply #1 on:** September 29, 2006, 11:49:53 PM »

Nick! Is Chandita gonna change it for you?!

A

Nick2k · « **Reply #2 on:** September 29, 2006, 11:52:28 PM »

Oooooh..you suck!

And, you're stalker.

I'm not sure what she used to remove her drain plug, but I guarantee it wasn't the right size!

Hopefully she didn't round off that plug too badly.

andrewsw · « **Reply #3 on:** September 30, 2006, 12:30:33 AM »

ha ha! gotcha.

well that sucks. ouch, I'll bet she was wankin' on that thing too... well, its better than splitting the oil pan!

A

oh, how about an adjustable wrench? i have a set of metric ones if that'll help... he he.

ttewejnodnarb · « **Reply #4 on:** September 30, 2006, 12:29:00 PM »

I wish this where a more usefull post, but it's the thought that counts...right?

I couldn't match it up with any metric socket I had either so I used a 13/16 IIRC. I wish I had a better memory, and I'm not home, but I think that's what it was.

gearset01 · « **Reply #5 on:** September 30, 2006, 01:59:09 PM »

2nd gens are 17 mm watcha got.
PIN

Nick2k · « **Reply #6 on:** September 30, 2006, 10:47:03 PM »

It's a 2001 1200cc, the mm size is larger than 19, but smaller than 22mm...that's my research on this so far.

gearset01 · « **Reply #7 on:** September 30, 2006, 11:09:19 PM »

Ron Ayers.com Item 7 oil pan 09247-14002 "plug" wrench size 17 mm.
same from 2001 on.
Unless someone replaced with aftermarket repair plug or there is a stock reduction from the MFG and in order to reduce inventory they will just stick anything in there with the same thread and length.
In this case use a MM ruler from the local hardware store and measure from flat to flat on the plug head, you may have to do this on your back since this particular task is conducted on the underside of the bike and really isn't a reach around job.

timjim · « **Reply #8 on:** October 01, 2006, 03:06:53 PM »

Just measured my sump plug and its 22mm

chupacabra · « **Reply #9 on:** October 02, 2006, 07:17:49 PM »

My oil drian plug takes a 21mm.
I just double checked it for you.

rfulcher · « **Reply #10 on:** October 10, 2006, 10:56:17 AM »

I just changed the oil in a 2001 B600 last night and the oil drain plug fit a 13/16 inch wrench exactly.

This is strange, I don't think 13/16 equals anthing metric:

13/16 = 0.812 5 inch [international, U.S.] = 20.6375 millimeter

WTF

Nick2k · « **Reply #11 on:** May 07, 2007, 02:33:10 AM »

Just to follow up on this, the plug size is 21mm...just as mentioned in an earlier post!