« previous next »
Pages: [1]

Author Topic: fitting a advancer  (Read 3775 times)

Offline blackbandit

  • Board Homesteader!
  • ***
  • Posts: 59
fitting a advancer
« on: September 30, 2007, 11:10:04 AM »
just got a 5 degree ignition advancer to put into bike (98 b12)how does one stop the rotor from turning whilst trying to undo
put it in gear but still turns  :duh:
Logged
long live the bandit

Offline chupacabra

  • Board Homesteader!
  • ***
  • Posts: 329
fitting a advancer
« Reply #1 on: September 30, 2007, 08:24:57 PM »
You remove the allen bolt in the center and the ignition advancer pulls out. Put a wrench on the ignition advancer to hold it and brake the center bolt loose, remove the bolt, the ignition advancer does not unscrew it just slides off.
Logged
Dave . . . San Diego, California
1996 GSF600S Marble Italian Red
I bought new in sept of 95
D.I.D. 530ZVM gold x-ring chain
Pirelli Diablo 120/60F & Strada 160/60R
Progressive fork springs
H.S. HD rear axle nut & washer
Hole Shot 17" comp1 can

Offline JamieK

  • Site Supporters
  • Board Homesteader!
  • ***
  • Posts: 276
fitting a advancer
« Reply #2 on: September 30, 2007, 08:57:22 PM »
Quote from: "chupacabra"
You remove the allen bolt in the center and the ignition advancer pulls out. Put a wrench on the ignition advancer to hold it and brake the center bolt loose, remove the bolt, the ignition advancer does not unscrew it just slides off.


Yup just how I did it :grin:
Logged
Jamie K in Edmonton<br />06 B12S, Full Muzzy, Stage 1 jets, Timing Advancer
Pages: [1]
« previous next »