Author Topic: Sump plug (Read 4588 times)

victor55 · « **on:** July 21, 2005, 06:19:55 AM »

Now I know you have probably been asked this question 1,000,000 times but I would like to know what size socket (metrically speaking) that I need for my K1 B12 sump plug.

Red, Pete, Ray or anyone feel free to advise me.

BTW how the hell are you all. I have been a bit quiet lately - must be the winter blues, but now that the solstice is well and gone, spring is just around the corner (down this way)

Cat Chew

chupacabra · « **Reply #1 on:** July 21, 2005, 06:34:22 AM »

I'm going to guess....22mm.

Red01 · « **Reply #2 on:** July 21, 2005, 06:48:54 PM »

Heck, I don't remember... I just reach for the socket that fits.
I don't think mine is in the 20's though... I have a limited selction of metric sockets over 19mm. I wanna say 18, but don't hold me to it.

gsxr400 racer · « **Reply #3 on:** July 22, 2005, 12:13:49 AM »

21mm if its like the rest of the suzuks

Bazza · « **Reply #4 on:** July 22, 2005, 03:55:22 AM »

It is 21 mm

victor55 · « **Reply #5 on:** July 22, 2005, 07:22:13 AM »

Thanks Team

tacoman · « **Reply #6 on:** July 22, 2005, 03:14:30 PM »

Its a 21mm. I bought my 21mm socket 20+ yrs ago when I had a FIAT X 1/9 (if anyone remembers those). I used it a lot on that car (FIAT stood for Fix It Again Tony!)

Red01 · « **Reply #7 on:** July 22, 2005, 07:13:52 PM »

They probably would have been better cars if they would have given you the other 8/9ths of it.

tacoman · « **Reply #8 on:** July 25, 2005, 02:35:49 PM »

That's pretty good, I'd never heard that one. It only had a 1200cc motor with a little weber carb so it was missing 8/9ths of any horsepower. Mid engine, it cornered like it was on rails.

sp2065 · « **Reply #9 on:** August 02, 2005, 09:17:09 AM »

I looked hi & lo and cannot find the torque specs (ft lbs) for the oil drain plug...can anyone help me out here?
On a side note I installed the Holeshot engine guards, pretty low profile I hope they are as strong is they claim to be.

Red01 · « **Reply #10 on:** August 02, 2005, 11:47:20 AM »

Just snug it down... too tight and you risk stripping it.

land_shark · « **Reply #11 on:** August 02, 2005, 01:14:15 PM »

Torque to 23Nm....or else!!!

ray nielsen · « **Reply #12 on:** August 02, 2005, 06:32:47 PM »

Or else use 16.5 lb/ft.