« previous next »
Pages: 1 2 [3]

Author Topic: Carbs gummed  (Read 10746 times)

Offline pmackie

  • Site Supporters
  • Board Homesteader!
  • ***
  • Posts: 1149
Carbs gummed
« Reply #30 on: May 17, 2007, 11:10:24 AM »
On my stock 2G B6, I shimmed the needles 0.5mm, drilled the pilot plugs and set the pilot jets at 2-3/4 turns out. Still stock mains.

A definite improvement in mid range and roll on performance. Well worth doing.

If your considering an aftermarket exhaust, it's almost a necessary change to put in a jet kit. Both Holeshot and Ivan's appear to have had good success with guys here.
Logged
Paul
2002-GSF600S, Progressive Fork Springs, B12 Shock,
SS Brake lines, EBC HH pads, Leo Vince Ex & Kappa bags.
Ex Bike Mechanic (late 70's), somewhat rusty
32 years in the Fuel/lubes industry(Retired)

Offline longislandbandit99

  • Board Homesteader!
  • ***
  • Posts: 96
Carbs gummed
« Reply #31 on: June 30, 2007, 12:09:05 PM »
Well I got Dale's Stage 1 kit with 5° ignition advance and today I will install.  Hopefully all goes well.  I'm sure I'll have a few fits but the directions seem pretty straight forward so maybe it will be a tad easier than I expect it to be.

His directions claim you can take the carb bank off and swing it up onto the motor top w/o removing the cables and taking it off the bike completely.  Anyone ever try this method?  I'll give it a shot but since I intend to clean them most likely they're coming off the bike.

I also got the carb sync package he sells.  Looks pretty straight forward, we'll see.
Logged
Pages: 1 2 [3]
« previous next »