Author Topic: Jetting stuff (Read 3457 times)

Vee Dub Nut · « **on:** June 01, 2005, 10:51:31 PM »

Im fixing to swap a low milage katana 750 engine in my high milage Bandit 600. I am using the Bandit 600 carbs which are 36mm CV carbs, and as far as i understand, i believe the Kat carbs were also 36mm. Now i have a stock header but a Vance and Hines slip on. Planning on a 5degree ignition advance as i do the swap, stock air box and filter.

Question,

Should i take out the snorkel in the air box, and or open up the hole?

What size jets do you recommend.. Im thinking 112-115's maybe? With a couple of shims under the needles of course... How about A/F screws?

IM just trying to get a starting point for the first start up, i will be continually tuning on it for the first coulple of weeks here and there..

Any help appreciated, im just bouncing around ideas right now.. thanks!

PeteSC · « **Reply #1 on:** June 01, 2005, 10:55:14 PM »

PM Bantana. He's been running a Kat 750 engine in 600 for about 4 years.

Vee Dub Nut · « **Reply #2 on:** June 02, 2005, 03:56:18 PM »

Thanks Pete...

I pm'ed him and hes allready gotten back with me!

Red01 · « **Reply #3 on:** June 02, 2005, 08:29:13 PM »

You might wanna post results for archival puposes in case someone else needs it and neither of you are around...

Vee Dub Nut · « **Reply #4 on:** June 02, 2005, 08:35:58 PM »

im planning on doing a whole write up on the swap.. there isnt much info out there on it, so it would be good for someone else down the road