Author Topic: Well, I DONE DID IT!  (Read 5255 times)

Offline B12Teuton

  • Board Homesteader!
  • ***
  • Posts: 543
Well, I DONE DID IT!
« on: November 28, 2005, 01:02:30 PM »
I finally got a new scoot...
2006 KTM 450XC


Not streetable yet, but has the electrical capacity and wiring to run dual sport lights.  It's also one of the only dirtbikes sold in the USA that comes with a 17 digit untainted VIN and no "off road only" crap on the MSO, so registration shouldn't be too difficult... I hope.

I put about an hour on it so far.  What a brute, and it's "only" a 450.

Now I just need a super motard setup! :bigok:
Manny
ATGATT (all the gear all the time!)
2006 KTM450XC Thump-whore

Offline Swamp Rat

  • Board Homesteader!
  • ***
  • Posts: 236
Well, I DONE DID IT!
« Reply #1 on: November 28, 2005, 01:48:43 PM »
Welcome to the dirt side. Good choice.
Brian
20003 1200s
2001 Drz 400e

Offline Desolation Angel

  • Board Homesteader!
  • ***
  • Posts: 1831
Well, I DONE DID IT!
« Reply #2 on: November 28, 2005, 01:50:54 PM »
Nice!  I'm partial to the 950s, myself.  One of these days I may have to get me one of them KTM scooters.

Had access to one many years ago...

Engine wasn't as big as yours, though. :grin:



Yes, that blue thing is a KTM! :stickpoke:

Offline PitterB4

  • Administrator
  • Board Homesteader!
  • *****
  • Posts: 3698
Well, I DONE DID IT!
« Reply #3 on: November 28, 2005, 01:53:10 PM »
Sha-weet!  Way to go, Manny.   :congrats:
Rob
Bikeless!
'93 Bandit 400 - SOLD
'98 Honda F3 Track Bike - SOLD
'98 Kawi ZX-6R Street Bike - SOLD
NESBA #87 - RETIRED
'00 Gary Fisher Kaitai
'09 Bianchi Via Nirone 7

Offline B12Teuton

  • Board Homesteader!
  • ***
  • Posts: 543
Well, I DONE DID IT!
« Reply #4 on: November 28, 2005, 02:10:41 PM »
Oh, it's got electric start too :grin:

About 250lbs wet and 50hp to the rear wheel.
Brembo brakes, hydraulic clutch and enough suspension adjustability to make your eyes water.  
Dealer's wrench went though it all with me, set the suspension sag and rejetted it for free.  It's a whole different experience than at a normal dealer.  A difference I can get used to.  Too bad the fee to get in the proverbial door is so steep.

Dirtbikes shouldn't cost more than street bikes.
But, you get what you pay for.
Manny
ATGATT (all the gear all the time!)
2006 KTM450XC Thump-whore

Offline WEINERDOGBONE

  • Board Homesteader!
  • ***
  • Posts: 359
Well, I DONE DID IT!
« Reply #5 on: November 28, 2005, 05:40:46 PM »
Mighty fine Manny.  :beers:

Offline tacoman

  • Board Homesteader!
  • ***
  • Posts: 793
ktm
« Reply #6 on: November 28, 2005, 05:51:13 PM »
Nice bike, my brother in law owns/runs jd jetting and just picked one up for further r & d on his new kit.  Its more than just jetting, he makes a custom tapered needle which really dials things in.  Check his site at jdjetting.com.  He makes these four strokes run sweet!

Offline Bantana

  • Board Homesteader!
  • ***
  • Posts: 130
Nice move Manny
« Reply #7 on: November 28, 2005, 06:15:47 PM »
Sweeet !  Get a tag for it and let's hookup at next year's Hooch dual sport ride.

~lloyd
~lloyd in atlanta
  Doing my best in the Southern Appalachians  to uphold the honor of Bandit riders everywhere.

Offline Red01

  • Board Homesteader!
  • ***
  • Posts: 8977
  • Are we having fun yet?
Well, I DONE DID IT!
« Reply #8 on: November 28, 2005, 07:01:32 PM »
A friend/co-worker bought a 450EXC with the KTM Street and Supermoto kits a few months ago. He had no problems getting it licensed for the street - but then he had it converted & licensed at purchase.
(He's got all the dirt bike goodies, too.)
Paul
2001 GSF1200S
(04/2001-03/2012)
2010 Concours 14ABS
(07/2010-current)


Offline PeteSC

  • Board Homesteader!
  • ***
  • Posts: 2525
    • SouthChinaLady
Well, I DONE DID IT!
« Reply #9 on: November 28, 2005, 09:24:04 PM »
It's about time, Manfred!

  You didn't go to the same dealer who pissed you off a couple of years ago?
Spartanburg, SC
'99 Bandit 1200
'03 DR650
I'm really a very hot, sexy,lesbian, trapped in this fat, middle-aged, male body......

Offline B12Teuton

  • Board Homesteader!
  • ***
  • Posts: 543
Re: ktm
« Reply #10 on: November 29, 2005, 06:57:11 PM »
Quote from: "tacoman"
Nice bike, my brother in law owns/runs jd jetting and just picked one up for further r & d on his new kit.  Its more than just jetting, he makes a custom tapered needle which really dials things in.  Check his site at jdjetting.com.  He makes these four strokes run sweet!


I've heard that JD is the only way to go for these bikes.  He gets lots of props on ktmtalk.com!
Manny
ATGATT (all the gear all the time!)
2006 KTM450XC Thump-whore

Offline B12Teuton

  • Board Homesteader!
  • ***
  • Posts: 543
Re: Nice move Manny
« Reply #11 on: November 29, 2005, 06:58:22 PM »
Quote from: "Bantana"
Sweeet !  Get a tag for it and let's hookup at next year's Hooch dual sport ride.

~lloyd


Let me know if you want to take it for a romp some time lloyd!
Manny
ATGATT (all the gear all the time!)
2006 KTM450XC Thump-whore

Offline B12Teuton

  • Board Homesteader!
  • ***
  • Posts: 543
Well, I DONE DID IT!
« Reply #12 on: November 29, 2005, 07:01:28 PM »
Quote from: "PeteSC"

  You didn't go to the same dealer who pissed you off a couple of years ago?


Nope, it's a brand new shop run by the most profesional crew I've ever dealt with for any purchase.  And that says a lot coming from me.

check them out:
http://www.promotosports.com
Manny
ATGATT (all the gear all the time!)
2006 KTM450XC Thump-whore

Offline NCBANDIT

  • Board Homesteader!
  • ***
  • Posts: 193
Well, I DONE DID IT!
« Reply #13 on: November 30, 2005, 08:59:48 AM »
Nice bike, I have been trying to get a quote from a local dealer on a 625 smc but haven't heard back from them. I may just have to go the route you went and get the wheels and conversion pieces myself.

If you don't mind, would you pm me a ballpark figure of what it cost you so I'll know what i'm looking at spending.
Josh

Offline tacoman

  • Board Homesteader!
  • ***
  • Posts: 793
jetting
« Reply #14 on: November 30, 2005, 01:42:01 PM »
On the jetting, send him an email.  He goes by James Dean.  He just got his '06 450 and has a new dyno with exhaust analyzer.  He should have some real good settings here shortly.  The nice thing about all the new 4 strokes is that they all share the same Keihin carb so he has lots of r & d time on this.