Author Topic: 92 gsf250p jet needle kit  (Read 2145 times)

Offline chamarang

  • Board Regular!
  • **
  • Posts: 12
92 gsf250p jet needle kit
« on: February 12, 2018, 02:22:11 AM »
 :duh:hi .last days i got carburator jet kit.main jet 105#,pilot jet 12.5#,starter jet 40#  and new jet. needle and needle how to adjust needle clip position and pilot air screw.

Offline ventYl

  • Board Homesteader!
  • ***
  • Posts: 248
Re: 92 gsf250p jet needle kit
« Reply #1 on: February 14, 2018, 02:06:21 PM »
Needle clip position: Needle jet should have groves near top end. Your old needle will have circlip inserted in it. You can select needle position by selecting which grove will host circlip. The further from end the higher needle will sit and the more fuel.

Pilot air screw will require some trial and error. Something like good startint position may be to turn screw out 2 + 1/2 turns from fully closed position. Ride it a bit and then try 2 and 3 turns from fully closed and re-test to see which runs smoother through whole throttle and RPM range. Fine tune this way. Usually changes smaller than 1/4 turns won't make noticeable difference.
Bandit 400 1991 - stock except of swap from GK75B to GK75A