Author Topic: Rear stand (Read 3738 times)

Skuzzer · « **on:** June 29, 2007, 03:28:24 AM »

I've just got myself a 92 GSF250 and I'm wanting to use a rear/paddock stand to lift it as I don't have a centre stand.
There isn't any holes to bolt pickup knobs into and the bottom of the swingarm is rounded making me a little wary of picking it up without knobs.

What do others do? :/

stormi · « **Reply #1 on:** June 29, 2007, 10:33:27 PM »

I have a stand made by lockhart phillips, it simply props up the bike by sitting under the swing arm.

Just make sure that whichever one you get is narrow enough to accommodate your bike's swingarm.

Here's an article about the one I have:
http://pages.infinit.net/mcrides/product_evals/lockhart/stand.htm

Oh,.. and Welcome to the forums!!

Skuzzer · « **Reply #2 on:** June 30, 2007, 07:11:00 AM »

Cheers, I'll go for the under swingarm method, and if it just feels too unsteady and I don't want to leave it like that I guess I could get some pickup knobs welded onto the swingarm...I doubt I'll do that tho.

stormi · « **Reply #3 on:** June 30, 2007, 01:50:45 PM »

The one I pointed you to is adjustable to some degree. I'm reasonably sure that it works on the Bandit that I have, but because she has a centerstand it's been a really long time since I've tried to put her on it. Perhaps I'll try to verify that later today for you.

You could also look at modifying the stand (a longer pin/bracket) rather than changing the bike...

PitterB4 · « **Reply #4 on:** July 04, 2007, 10:09:51 AM »

The LP paddle stand is JUST narrow enough to take the B4 swinger.... unless you bend the arms in a little like I did.

Worked like a charm, then.

stormi · « **Reply #5 on:** July 04, 2007, 02:16:11 PM »

Is that the same one I pointed him to, or another LP one?

I suppose, since she's home for a change, that I could just go out and check on her to see...

PitterB4 · « **Reply #6 on:** July 05, 2007, 07:04:48 AM »

Same one, Storm. It had to be lined-up perfectly or one side or the other would pop off when I was trying to lift it. Almost dropped the bike several times. So... I laid the stand on its side and pushed the arms together until it bent in an inch or so... PERFECT!

stormi · « **Reply #7 on:** July 05, 2007, 11:30:04 AM »

Good job!!

I would have changed the pins, but that works too. Does it still fit the new bikes too?

PitterB4 · « **Reply #8 on:** July 05, 2007, 10:47:28 PM »

Quote from: "stormi"

Good job!! I would have changed the pins, but that works too. Does it still fit the new bikes too?

It does now that I stretched it back out! The CBR uses the narrower pin position and the ZX just barely makes it inside the wider one. Both bikes have spools so I really should get a better stand the lifts by them. I am too cheap to replace something that works.

stormi · « **Reply #9 on:** July 06, 2007, 03:52:27 AM »

Quote from: "PitterB4"

I am too cheap to replace something that works.

no that's great!! Stick with what works!