Author Topic: ENGINE VIBRATION  (Read 11104 times)

Offline ray nielsen

  • Board Homesteader!
  • ***
  • Posts: 227
ENGINE VIBRATION
« Reply #15 on: February 08, 2006, 08:40:14 PM »
So far nobody has mentioned the Throttle Position Sensor (TPS) adjustment.  It does make a slight improvement IF it's spot on and the carbs are properly synchronized.

The factory manual describes it best, but is a bit confusing until you read it several times.

The overall resistance of the unit should be noted and then at full throttle with the engine off and the key on you adjust for 75% of the value noted in the earlier step.

I think there's a good write up copied from the factory manual -- it should be findable in the archives.

Offline 2RRS

  • TURBO TYPER!
  • **
  • Posts: 24
ENGINE VIBRATION
« Reply #16 on: March 12, 2006, 08:16:18 AM »
I have an 05 bandit that had a vibration problem as well but have found it to be the fairing that was the cause. After using rubber washers on both sides of the fairing bolts the problem was solved.
Quiet as a mouse
K3 1200 - Blue
2012 Hayabusa - Black
K5  1200  LE - RIP