winter rebuild

[TJS]

My front sprocket is 16mm thick. The one like Unique is using from Talon is 14.5mm

[TJS]

Sycn the carbs:


http://www.youtube.com/watch?v=2mYlVHf3spU

Motion Pro video on " How to.."

http://www.youtube.com/watch?v=2nwP6R1P58A

[TJS]

My new Talon sprocket from across the pond. 14T /  520 /  16mm

[El Gringo]

Cool, that's a pretty quick turn round on a special sprocket 

[TJS]

Talon sprocket on the bike.

[Unique]

  Yes that was very quick

Perhaps any future orders of these Talon sprockets will be as quick as Talon now have the basic setup in their software, you only need to give them the offset you need!.

[TJS]

Unique,
Thanks to you...We all can get quality sprockets!

[TJS]

Factory Pro Stage III instructions:

[yoda]

Hi TJS your frame looks fantastic powder coated. I love the GSXR forks and RF swingarm too. Maybe in the future for mine! Thanks for putting all the info and pics on, it all helps plan my project too...! I'm still in the 6x8 shed

[B4ndit]

Yes it looks great...!!! just hoping to get mine up and running

[TJS]

My pics and video were just added to the Factory Pro website:

http://www.factorypro.com/Prod_Pages/prods41.html

[TJS]

Just want to remind everyone that you only have to mill the rear sprocket hub; if you use a machined RM 250 front sprocket or any sprocket less than 16mm or 15mm total width. The first pic is a RM 250 machined down. Second: Two RM 250s welded and machined, and finally the Talon was installed as seen above.

[TJS]

warning! warning! warning!
This has been stated before: If you have the rear sprocket hub machined; make sure the machinist doesn't remove the thin sprocket alignment lip!

[B4ndit]

What frame sliders are you using?

[TJS]

Comes in or black. The guy will also do custom.