Author Topic: Quick question about needle seat on GEN2 bandit  (Read 3094 times)

Offline rider123

  • Board Homesteader!
  • ***
  • Posts: 991
Quick question about needle seat on GEN2 bandit
« on: May 12, 2012, 11:06:03 AM »
Hey guys number 4 carb is leaking fuel enough that the overflow is overflowing when driving. I'm going to take that carb apart and check the obvious stuff ie needle valve, seat, emulsion tube o-ring etc. The microfiche is kind of shit but it looks like the needle seat is press fitted, correct? So I'm assuming I can just get a dental pick or open up the top of the carb and pull or push it out correct?
2005 Bandit 1200, Modified Holeshot Stage 1 with 17.5 pilots 2.75 turns out, and 110 mains 5 shims. Muzzy Slip on w/mid-pipe, stock filter. 1.5" hole in the airbox lid.

Offline rider123

  • Board Homesteader!
  • ***
  • Posts: 991
Re: Quick question about needle seat on GEN2 bandit
« Reply #1 on: May 12, 2012, 03:15:16 PM »
Nevermind, fixed it, crud on the needle seat.  :duh:
« Last Edit: May 13, 2012, 07:05:48 PM by rider123 »
2005 Bandit 1200, Modified Holeshot Stage 1 with 17.5 pilots 2.75 turns out, and 110 mains 5 shims. Muzzy Slip on w/mid-pipe, stock filter. 1.5" hole in the airbox lid.